Cd player belt slipping. Need help with a CD player fix........bad belt??

But not easy to find that BELT. I just used a comparable sized rubber band. Check out the video below to understand how replacing a belt works in less than three minutes:. New Posts. Search Advanced search…. Radni14 said:.

 

1: Remove the belt in question, clean the belt and don't forget the pulleys with Methylated Spirits (alcohol) · 2: Boil the belt in boiling water.If the problem with your belt is not its deteriorating flexibility, this forum might be useful in providing solutions to niche concerns.

 

cd belt slipping The motor that opens the CD drawer stutters when opening the drawer on my CD player, like the belt - Onkyo Audio Players.Did U have any experience with it?Forum Cd player belt slipping

 

farmasiuyelik.online › audiorepair › comments › sony_cd_player_belt_slippage.It works for as long as it works Its an old trick of the repair trade.

 

Hi, I just got a sony 5 disc CD player and it is not cycle ing through the disc slots, I narrowed it down to this one belt slipping on the.Found the belt at MCM elecronics but it is.

 

I picked up an Optimus CD player. Well I have discovered that the problem is most likely a belt that seems to be slipping.Common talcum powder.

 

farmasiuyelik.online › watch.Find More Posts by saxmaniac.

 

I have a CD palyer Cary Audio CD (I guess ). It has CD drive mechanism CDM Still the old belt was slipping.Re: Boiling rubber drive bands Thanks guys, all very interesting.

 

Well in 99% of cases it's due to the rubber drive belt becoming loose, This causes the drive motor pulley to slip resulting in a.Re: Boiling rubber drive bands In my experience - and in fairness I have done many - the best way to rejuvinate an idler wheel is stick some fine wet and dry paper down on a kitchen work surface a hard flat surface and using a sweeping motion to avoid creating flats, wipe the idler across the paper, moving it around to a new section before each sweep.

 

If the motor shaft leans slightly toward the platter, the belt will Replace the c-clip and mat, and plug the player in if it's smooth.Yes, my password is: Forgot your password?

 

Cassette, Wire and Magnetic Disc Recorders and Players. this to the loading drive belt on my lates Technics SL-P CD player.I put a pot of water on my stove and brought it to a rolling boil.

 

I think it's something to do with rearranging the long chain polymers.

 

This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.

 

Job done.

 

I often try it if I don't have a replacement to hand as there's nothing to lose.

 

Why Does My Turntable Belt Keeps Slipping or Falling Off? forum? From the heart, Thank You!

 

This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.

 

Prices range from reasonable to outrageous.

 

Oddly enough, the belt will sound better on one side than the other, so experiment by drawing a line with a felt pen or a dot of paint on the side you choose.

 

Your email address will not be published.

 

forum? The downside of rubber bands is they may only last 3 — 6 months.

 

How it can be possible to replace the belt?

 

The belt attaches to it, spinning the turntable as the motor rotates.

 

It certainly gets the thing going while you waste hours on the net looking for replacement belts of the correct size when you don't actually know what size they should have been in the first place, and then you buy a kit for said model and the belts turn up the wrong size

 

They can range from 20mm to 50mm in diameter.

 

I often try it if I don't have a replacement to hand as there's nothing to lose.

 

Re: Boiling rubber drive bands Thanks guys, all very interesting.

 

Any potential electrical shocks will be avoided, albeit they should be rare.

 

Re: Boiling rubber drive bands I have a feeling that there is also something in the soap powder that may help restore the belt.

 

Then repeat.

 

Posts: 3,

 

forum? Many old drives have been thrown out due to this problem which is actually quite easy to fix.

 

Jump to Latest.

 

I did it once in the magnetic card reader in an HP calculator.

 

I also added some stain removing granulated cleaning stuff, similar to Vanish, but Sainsburys own brand.

 

So are you saying the the drawer opens and closes - doesn't load the disc - and then opens again?

 

Job done.Forum Cd player belt slipping

 

Search Advanced search….

 

To reach in and touch the motor, line up one of the access holes on the platter.

 

Messages: 71, Location: Fort Dodge, Iowa.

 

New Posts.

 

It seems to work best when the belts are just a bit tired rather than completely knackered.